| Installation of a support for 1 post |
|
 |
 |
 |
|
|
|
Choose a location to install the caliper. Snap the support into the cable duct and turn the locking tabs 90 °.
Connect the cable to a power outlet. Install the socket mechanism into the caliper. Place the frame on the caliper and snap into place. |
|
|
|
|
| Installation of a support for 3 posts |
|
 |
 |
 |
|
|
|
Choose a location to install the caliper. Snap the support into the cable duct and turn the locking tabs 90 °.
Connect the cables to the outlets. Install the rosette mechanisms into the support. Snap the frame onto the caliper. |
|
|
|
|
| Wall entry (ceiling) |
|
 |
 |
 |
|
|
|
| Installation of the bushing is carried out by snapping the fixing elements into the guides on the cable channel. |
|
|
|
|
| Joint connection |
|
 |
 |
 |
|
|
|
Butt joint using independent parts - joint on the joint of the cover and joint on the base of the cable duct.
The section connector must be inserted into each subsequent section from the ends during installation. |
|
|
|
|
| Setting a flat corner |
|
 |
 |
 |
|
|
|
Fasten the trunking to the wall, perpendicular to each other. Install the rear corner cover, the fixing elements of the corner
overlap on the end surfaces of the cable ducts. Snap the cover into the guides on the box body. |
|
|
|
|
| Installation of a partition |
|
 |
 |
 |
|
|
|
| Fix the cable duct to the wall. The partition is installed into the cable duct by snapping onto the guide located on the base of the cable duct. |
|
|
|
|
| Setting the inner corner |
|
 |
 |
 |
|
|
|
| Fix the cable duct 140 mm from the corner of the wall (use the base of the corner as a template). Install the corner base so that the corner fixing elements overlap on the end surfaces of the trunking. Snap the cover into the guides on the box body. Slide the covers until they lock under the corner cover. |
|
|
|
|
| Setting the outer corner |
|
 |
 |
 |
|
|
|
| Secure the trunking to the outside corner of the wall (use the base of the corner as a template). Install the corner base so that the corner fixing elements overlap on the end surfaces of the trunking. Snap the cover into the guides on the box body. Slide the covers until they lock under the corner cover. |
|
|
|
